|
This maintenance guide will show you how to disassemble every working part of
the Ringblaster Mark IV Industrial Tool. If this system has been leased to you,
any factory authorized parts requiring replacement due to normal use and wear
will be shipped to you at no charge. You pay shipping charges only. If you find
it necessary to replace any parts, order by number, and write, call or fax:
Winchester/Olin Corporation
Attn: Industrial Customer
Service
427 North Shamrock Street
East Alton, Illinois 62024-1197
Tel: East (618) 258-3534 | West (618) 258-3556
Fax: (618) 258-3446
E-mail East: FGBooth@olin.com
E-Mail West: OJMiles@olin.com
Because of the extremely adverse conditions under which this equipment must
operate, special care should be taken in maintaining it.
- Always cover the equipment when not in use.
- All moving parts inside the receiver and Breech block should be cleaned
periodically with a non-petroleum solvent to remove dirt. We recommend a silicon
lubricant. Do not oil any exterior parts since oil will attract dirt.
- After each shooting, the shell chamber should be cleaned using non-petroleum
based solvent and Chamber Cleaning Brush #R003. The Chamber Cleaning Brush is
provided with every Mark IV. The #R003 Chamber Cleaning Brush can be ordered
separately or is provided in the #R499A Cleaning Kit.
*NOTE: Portable shooting stands are not furnished by Winchester. Customer may
obtain technical drawings by ordering form E-3-5/86.
|